![]() ![]() You rotate those which are attached to a concentric piece of plastic that makes the adjustment. There are a couple of screws by the adjusting knob. These were off from the factory and it took me a while to figure out how to adjust them and even then, it was a pain. Probably the biggest complaint I have is the 90° and 45° stops. But once it gets going, it sounds like a circular saw. ![]() Saw start up is loud and sounds like the motor and blade are going to come flying out of the cabinet. It is more like measure once, adjust, measure again, adjust some more, measure again, adjust once again, tap on the fence or table, measure again and then if you are comfortable with the setup, make your cut and hope for the best. The standard "measure twice cut once" rule does not apply here. Even then, double check the distance between the fence and blade.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |